User manual

ENGLISH

PART NAMES AND FUNCTIONS

7. Tempo Control Range selector button

Each time this button is pressed, the tempo adjust slider’s variable range alternates between ±6%, ±10%,

±16%, and 100%.

8. Key Lock

This function allows the tempo or BPM of the music to be altered without affecting the musical key. While this

button is illuminated, the key will be locked at zero.

9. Tempo Adjust Slider

This slider is used to adjust the playback pitch percentage.

10. Pitch Bend +/- Button

The desired pitch decrease or increase when button is pressing and returns to the original pitch when the button

is released.

11. TAP /Auto BPM button

Tap along with the music to enter manual BPM values for use with FX & Auto Loop. This is generally used to

manually calculate BPMs when the Auto BPM function is unable to lock onto a consistent beat. You must tap at

least four times in order for a calculation to occur, and the calculation will only be as accurate as your tapping.

NOTE

: Using this button will disengage the Auto BPM function. To return to Auto BPM, simply hold

down the Tap button until the display reads A.BPM in the display screen.

12. Sample Button

Press this button, then press the desired BANK button to set the sample loop mode (LED is on). When sample

mode is set, then sampler will mix the music together. And press the SAMPLE button again to set the sample

single mode (LED is ﬂash). Press the SAMPLE button again to cancel sample function.

13. Bank Pads 1,2,3,4

These buttons are used to store either four cue points or four samples. Each Bank Button can store either a

sample or a cue point. For Hot Cue the illumination is Orange. For Loops the illumination is Blue.

NOTE

: While the Pad is ﬂashing, you can modify the saved data in this pad.

14. Hot Cues/Loops Record and Recall button

This button can be used in couple of ways:

1) Press this button to activate the record mode, the button LED will glow when active. After the record mode

is activated, press your desired bank button

to store your Hot-cue point or playing loop. The bank pad can

also be overwritten in the same way.

2) To store your loops and hot-cue points saved in the BANKS to the system memory for next time. Press the

REC button for 1 second and the button ﬂashes.

NOTE

: RECALL MEMORY: The Player can store 2000 programmed cue points in CDs and 4

programmed cue points per track in the USB device. These setting may be recalled at any

time, even when an audio source has been removed and loaded at a later time.