User manual

P70
Digital Media Player Controller
&
73
ENGLISH
OPERATIONS
•
Modifying Loops
- To Adjust LOOP Out point
Once a seamless loop is created, the OUT point can be changed without stopping the loop play.
Step 1 : During loop play, press the LOOP OUT button
44
. The time display will show the out-point time; the
LOOP OUT button will change to quick flashing, while the LOOP IN button
43
light will off.
Step 2 : Rotate the jog wheel to the desired OUT point. The loop out point will change in one-frame
increments.
Step 3 : Press Loop OUT button
44
again to save the new OUT point and exit the modifying loops mode to loop
play mode.
- To Adjust LOOP IN point
When a seamless loop is created, you also adjust the LOOP IN point. However, the loop play will be paused.
Step 1 : During loop play, press the LOOP IN button
43
. The loop play is paused and the time display will
show the in-point time. The LOOP IN button will keep flashing, while the LOOP OUT button
44
light
will off.
Step 2 : Rotate the jog wheel to the desired IN point. The loop IN point will change in one-frame increments.
Step 3 : Press Loop IN button
43
again to save the new IN point and exit the modifying loops mode to loop play
mode.
How to Set Auto Loops
Auto loop enables BPM determined sections to be recorded by only defining the in-point of the loop. The BPM
engine determines the out-point, based on the selected Time Division. For example, if the tempo is 120 BPM and
the time division is 1/1, a loop will be created that is 2 seconds in length.
•
To set a Auto Loop
Step 1 : Setting the Auto Loop length
Switch the FX Sync & Auto Loop Set Switch Button
33
to LOOP SET.
Press the desired Loop Length
31
by using the Plus button
32
and the Minus button
30
. Select the loop
length of 1/64, 1/32, 1/16, 1/8, 1/4, 1/2, 1, 2, 4, 8, 16 (1 bar = 4 beat) at which you would like to start
your desired loop.
Step 2 : To active the Auto Loop Mode
Press the Auto Loop button
41
to active the Mode.
Step 3 : Setting the LOOP IN point
Press the LOOP IN button
43
to set the start point of the loop. The end of the Auto Loop is determined
by the loop length and current BPM.And the Auto Loop begins.
Step 4 : Changing the Auto Loop Length
During the Auto Loop playing, you can change the loop length by press Plus button
32
and Minus button
30
. The display indicates loop length as “LOOP Length” .
Step 5 : Stop a loop
Press the RELOOP/EXIT button
45
to exit the loop.