User manual

M10
23
ENGLISH
PART NAMES AND FUNCTIONS
27. Phone/Line input jacks
The type of input must directly reflect the selected mode of the SOURCE SELECT SWITCH
1
. Turntables
equipped with MM pickup cartridge (All DJ turntable use MM pickup cartridges) may be connected to these
jacks as long as the SOURCE SELECT SWITCH(1) is in the left side “PH/LN” position and the LINE/PH selector
switches
26
is in the “PH” position. CD players, Tape Decks and other line level instruments may only be
connected to these jacks as long as the LINE/PH selector switches
26
is in the “LINE” position. Input volume
will be controlled by the Input gain control knob
16
.
28. Line input jacks
These Jacks are used for line level inputs. Connect CD players or Tape Decks to line level inputs. Input volume
will be controlled by the input gain control knob
16
. The channel Source input selector switch
1
must be in the
"LN (Line)" position, to monitor any source connected to these jacks.
29. Rec output
This is a low current unbalanced output source designed for various tape and CD recorders. The Record Out (REC
OUT) level is dictated by the Channel fader
9
, it is not influenced by the MASTER VOLUME CONTROL
4
.
30. Master output
The RCA jacks send a low current unbalanced output signal. These jacks should only be used for shorter cable
runs to signal processors or looping to another mixer.
31. Dc in
Use the included power adapter to connect the mixer to a power outlet. While the power is switched off, plug
the power adapter into the mixer first, then plug the power adapter into a power outlet.
NOTE
: The mixer is designed to work with the included power adapter only. Using an incompatible
power adapter could result in damage to the unit.
32. Headphones jack
Used to connect your headphones to the mixer.
FRONT PANEL
32