User manual

ENGLISH

1. Make certain power is off while making connections.

2. Quality cables make a big difference in ﬁdelity and punch. Use high-quality, audio cables.

3. Do not use excessively long cables. Be sure plugs and jacks are securely fastened. Loose connections cause

hum, noise, or intermittence that could damage your speakers.

4. Connect all stereo input sources. Then connect any effects into the stereo Effect, if used. Connect your

Microphone(s) and monitor headphones. Make sure all faders are at “zero” and the unit is off. Take care to

connect only one cable at a time. Pay attention to L and R position of jacks, on both the VOXOA M10 and

outboard gear.

5. Connect the stereo outputs to the power amplifier(s) and/or tape deck(s) and/or MD recorder(s) and/or CD

recorder(s).

CAUTION

: Always switch on your audio input sources such as CD players ﬁrst, then your mixer, and ﬁnally

any ampliﬁers. When turning off, always reverse this operation by turning off ampliﬁers, then

your mixer, and then input units.

CONNECTIONS