User's Manual

10
TOUR OF THE DOORBELL CAMERA
FRONT AND BOTTOM
BACK
RESET button (left side) restores the
doorbell camera to factory settings
(hold for 15 seconds).
Micro SD card slot (right side, not
shown) holds the micro SD card that
comes with your doorbell camera.
Mic captures audio around the doorbell.
Lens captures video in front of the doorbell.
IR light (behind panel) activates automatically
for night vision.
Call button sounds the doorbell.
Indicator light shows the camera status:
Solid blue when starting up and working
normally
Flashing blue and red when WiFi is not
connected
Flashing red when the doorbell camera is
updating its rmware
Flashing blue when the doorbell camera is
calling the App
Off when the doorbell camera is
communicating with the App
Speaker (bottom, not shown) broadcasts
your voice when talkback is activated.
Screw terminals 1 and 2 connect to the power
source from your home.
Your doorbell camera comes with an SD card pre-installed, for recording alerts.
To remove or replace this card, you’ll rst need to remove the doorbell camera’s
faceplate by unlocking its set screw and pressing on its bottom and top and pulling it
o. Then use the included set screw tool to gently pry the bottom of the SD card slot
(on the right side) open. Press the installed SD card to unlock it and pull it out. Place
the new SD card in and lock it into place. Then place the SD card cover back on and
put the doorbell camera’s faceplate over the doorbell camera. Finally, insert the set
screw and screw it back in place.
Removing/Replacing the SD Card