User's Manual

4
IMPORTANT! Handle the doorbell camera carefully! Make
sure not to scratch its lens.
Connect the doorbell camera to home power
6
Check if your home’s doorbell power wires are long enough to
connect directly to the terminals on the back of the doorbell
camera.
Loosen
Doorbell
camera
back
Terminals
If your home’s doorbell power wires are long
enough:
Use the screwdriver provided in this package
to loosen the terminal screws on the back of
the doorbell camera.
Terminals
Home
doorbell
wires
Tighten
If your home’s doorbell power wires are NOT
long enough:
Use the wire leads and wire nuts included in
this package to connect them to the doorbell
camera.
First, put the ends of one wire lead and one
home doorbell wire together and insert them
into a wire nut. Then twist the wire nut until
you feel tension. Repeat with the other wire
lead, home doorbell wire, and wire nut.
Home
doorbell
wires
Wire nut
Twist
Wire
leads
Unscrew
& remove
Doorbell
camera
back
Terminals
Connect the doorbell power wires directly
to the terminals on the back of the doorbell
camera. Loop each wire end around each
terminal on the back of the doorbell camera.
Note: It doesn’t matter which wire you put on
which terminal.
Tighten the screws to hold the wires rmly in
place.
Next, unscrew the terminal screws on the back
of the doorbell camara and remove them.
Place each screw through the ring on the other
end of each wire lead, then screw the terminal
screws back onto the doorbell camera.
Tighten
MOUNT THE DOORBELL CAMERA (continued)