Installation Guide

UNIVERSAL INSTALLATION 10”.1 SEATBACK ENTERTAINMENT SYSTEM (Seat Back Mount)

Page 2 of 8

730148A1

A. Pre-Installation Precaution

1. Use Seat and Floor protectors to avoid damage

to surfaces.

Disconnecting the battery prior to any ground or harness

removal/ tapping to prevent possible vehicle damage is

recommended. The battery may be temporarily reconnected

and disconnected throughout the installation process to

perform various tasks. However, prior to doing so all

connectors and harnesses must be reassembled and

reconnected. Once tasks are completed disconnect battery

until installation is complete and DVD system is ready to be

tested. After testing, the vehicles interior may be re-

assembled. If the vehicle is equipped with an Anti-theft radio,

the code must be written down prior to disconnecting the

battery cable. The code must be re-entered when the negative

battery cable is re-installed. Disconnecting the battery may

cause certain vehicle settings to be lost. Manufacturer’s

recommendations for the battery removal should be followed.

B. Disassemble Vehicle Trim

1. Remove headrest by depressing release buttons

on each of the post guides and pulling up on the

headrest. NOTE: Some vehicles headrest will

remove by different methods. (Figure B1a-b)

2. Remove seat back plastic. NOTE: Some

vehicles seatback will remove by different

methods. Some seats may be soft and only

open at bottom section of the seat.

(Figure B2a-b)

Figure

B1a

Figure

B1b

Figure

B2a

Figure

B2b