Installation Guide

UNIVERSAL INSTALLATION 10”.1 SEATBACK ENTERTAINMENT SYSTEM (Seat Back Mount)
© 2018 Voxx Automotive, Inc. All rights reserved.
Page 3 of 8
730148A1
C. Seat Harness Routing
1. Insert a NRT carefully between the guide sleeve
and seat material creating a gap between. The
NRT will then slide down between the foam and
the frame. Once down, twist the NRT to create a
larger gap. NOTE: In some seats you may
have to remove the guide sleeve to properly
slide the NRT between the foam and frame.
(Figure C1a-c)
2. Route the straight end of the L Connector
harness down between the frame and foam. DO
NOT route through the guide post hole.
Continue to pull the harness through the seat,
exiting the lower seat opening. (Figure C2a-b)
Figure
C1a
Figure
C1b
Figure
C1c
Figure
C2a
Figure
C2b