Installation Guide

UNIVERSAL INSTALLATION 10”.1 SEATBACK ENTERTAINMENT SYSTEM (Seat Back Mount)

Page 8 of 8

730148A1

6. Re-install headrest. NOTE: Some slight

modification may be done to the bracket

cover to allow headrest to move up and down

freely. (Figure E6)

7. Continue routing harnesses following factory

harnesses from the lower seat to a central

location in the vehicle. Attach to T-Junction

harness.

F. Power/Ground Location

1. Locate an Accessory Power source (+12 VDC

should be present when the ignition key is in the

accessory and run positions. 0 VDC should be

present when ignition key is in the off position).

Locate a good ground. Generally, these wires

can be located at ignition switch, power outlet, or

fuse box. NOTE: Ensure that the switched

power is fused at the source. Failure to do so

may result in vehicle and wiring damage.

G. Reassemble Trim

1. Trim all wire tie ends

2. Reassemble all trim removed in earlier sections.

H. Complete Installation

1. Install (2) AAA batteries in each headphone set.

2. Store remotes, owner’s manual and

headphones in center console, glove box, or

seat back pockets.

Figure