Installation guide
VEHICLE PREPARATION:
1) Read the manuals and get familiar with the electrical requirements and
connections.
2) Prepare the vehicle by removing any interior trim necessary to gain access to
the vehicle’s wiring as well as all areas where interconnecting wire harnesses
will be located. The mounting method and the location will vary from vehicle
to vehicle, so this manual will only focus on the installation of the Master
and Satellite Monitors in the supplied conguration. The best location for the
HR7012M/HR7012S System components are:
a) Monitors: Vehicle-specic Headrest
Note:
The M1 monitor should be installed in the passenger position most used.
- The M1 monitor has the pink/green connector.
- The M2 monitor has the blue/green connector.
b) Wireless FM Interface Box: Under either seat where monitors are located.
3) Locate an accessory power source (+12 VDC should be present when the
ignition key is in the accessory and run positions. 0 VDC should be present
when the ignition key is in the OFF position) and a good ground. Generally,
these wires can be located at the ignition switch or fusebox.
Note: Ensure that the switched power is fused at the source. Failure to do so
may result in vehicle wiring damage.
4) Run the wiring harnesses throughout the vehicle as necessary. (Refer to
the Wiring Diagrams, as well as the wiring instructions for the individual
components and accessory options being installed.) Be sure that all the
wiring is protected from sharp edges and is routed in such a manner that it
will not be pinched when it is fully installed. Be sure to leave enough slack
in the wiring at each component to allow sufcient working room. Be sure to
leave enough slack in the monitor cables to allow the headrest to move up or
down, and the seat to move backward and forward.
Note: Do not interfere with air bags or air bag wiring.
5) Remove all the components from their packaging and then place them in the
vehicle at their respective locations.
6) Install the Headrests:
a) Remove the vehicle’s original Headrests.
b) Hold the Headrest above the seat and insert the two cables into the
headrest support tube holes. Make sure that the headrest is in the correct
position (Display facing the rear).
c) Route the cables through the seat back and out the bottom of the seat.
d) Place the Headrest support tubes into the support tube holes while pulling
the cables to remove the slack. Be sure to leave enough slack in the
monitor cables to allow the headrest to move up or down.
7