Owner`s manual

HR7012 REAR SEAT VIDEO HEADREST SYSTEM Owner’s Manual

REMOTE CONTROL BATTERY INSTALLATION

Installation of the Remote Control Battery

Figure 11

Figure 12 Figure 13

The remote control comes with a battery already installed with a Pull Tab to prevent battery

discharge. Remove the Pull Tab before using the remote control for the rst time. (Figure 11)

NOTE: The remote control will only operate with the HR7012 rear seat video headrest system.

It is not a universal remote control and will not control other equipment.

Remote control

Back View

Protective Pull Tab (Clear Plastic)

(1)

(2)

(1)

Replacing the Remote Control Battery

1. While holding the remote control,

insert thumbnail into the battery door

side notch (1) and index ngernail into

battery door upper notch (2) and slide

battery holder open. (Figure 12)

2. Remove the old battery and discard.

3. Install a new CR2025 battery (1).

(Figure 13)

NOTE: Make sure that the proper polarity

(+ or -) is observed.

4. Slide the battery holder back into the

remote control until it locks. (Figure 13)

CR2025