Owner`s manual

15
HR7012 REAR SEAT VIDEO HEADREST SYSTEM Owner’s Manual
Each wireless IR headphone requires two AAA batteries.
1. Locate the battery compartment cover on the left earphone.
2. While holding the left earphone in one hand, press down on the battery compartment
cover and slide it UP and OFF in the direction shown. (Figure 14)
3. Insert two AAA batteries, carefully following the markings inside to ensure the batteries
are inserted properly ( “+”and “
-” ends in the correct positions).
4. Replace the battery compartment cover. (Figure 14)
Installation of the Headphone Batteries
HEADPHONE BATTERY INSTALLATION
Figure 14
• Always keep the monitors, remote
controls and headphones clean and dry.
• Always seek qualied personnel to
perform repairs to the system or
individual components of the system.
Never attempt your own repairs.
• Do not drop remote controls and
headphones or expose to strong
impacts.
• Do not expose monitors, remote controls
and headphones to direct sunlight for
extended periods of time.
• Always ensure that the batteries are
correctly installed in the remote controls
and headphones with the positive and
negative sides in the directions as shown
in the battery compartment.
• Use one CR2025 (3V) Lithium battery
(160mAh) in the remote controls
NOTE: Do not use dierent types.
• Use two AAA (1.5v) Alkaline batteries in
each of the headphones.
NOTE: Always use fresh Alkaline Batteries
of the same brand, Do not use dierent
types.
• Do not use old batteries in the remote
control or headphones.
• When the batteries fail to function, replace
them immediately.
• Remove the batteries if the remote
controls and headphones are not used for
a month or longer.
• Keep all batteries out of the reach of
children. Should a battery be swallowed,
immediately consult a doctor.
• When disposing of used batteries, please
comply with governmental regulations
or environmental rules that apply in your
area.
BATTERY CAUTIONS AND WARNINGS
Cautions and Warnings