Owner`s manual

HR7012 REAR SEAT VIDEO HEADREST SYSTEM Owner’s Manual

SYSTEM SETUP SUBMENUS (continued)

DEFAULT AUTO ON/OFF ONLY AVAILABLE ON HR7012S

Default AUTO ON/OFF from the Front Panel (Figure 29):

1. Press and hold the MENU/SELECT button on the front panel (Figure 19) of the system for

3 to 5 seconds to show the System Menu. (Figure 29)

2. Use the UP/DOWN direction buttons to select DEFAULT AUTO ON/OFF and press the

MENU/SELECT button to enter the sub-menu.

3. Use the UP/DOWN direction buttons to select Default Auto AV, M1 or OFF and press the

MENU/SELECT button to enter selection.

NOTE:

• Default Auto AV: HR7012S monitor(s) will automatically turn ON when a connected

video source is detected and turned ON. NOTE: This feature will only work if the system

is installed with an external source connected to the A/V IN of the unit.

• Default Auto M1: HR7012S (M2) monitor(s) will automatically turn ON when the

HR7012MA (M1) is rst turned ON.

• Default Auto OFF: HR7012S (M2) monitor(s) will not turn ON automatically when

HR7012MA (M1) is turned ON or if a connected video source is detected and turned ON.

Default AV AUTO ON/OFF from the Remote Control

1. Select “M1” or “M2” on the Remote Control.

2. Press the SYSTEM MENU button then use the UP/DOWN direction buttons (Figure 15) to

select DEFAULT AV AUTO ON/OFF and press the ENTER button to enter the sub-menu.

3. Use the UP/DOWN direction buttons to select DEFAULT AV AUTO ON/OFF and press the

ENTER button to enter the sub-menu.

Figure 29

HR7012S (M1)

HR7012S (M2)