Owner`s manual
40
HR7012 REAR SEAT VIDEO HEADREST SYSTEM Owner’s Manual
TROUBLESHOOTING
Symptom Remedy
Device does not power “ON” • Is the ignition turned “ON”?
• Is the screen rotated to the operating position?
• Are batteries installed in remote control?
IR sensor inoperative • Verify that the batteries in the remote control are good.
• Verify that the remote sensor eye is not obstructed.
• Verify that M1 or M2 has been selected correctly.
Disc won’t play • Insert a disc with label side facing toward user.
• Check if the disc is defective by trying another disc.
• Check the type of disc you put into DVD compartment slot.
This DVD player only plays DVDs, audio CDs, and MP3s. It
will not play a Blu-ray disc.
• Both the device and the disc are coded by region. If the
regional codes don’t match, the disc can’t be played.
Disc plays, but then stops
immediately
• The disc is dirty and needs cleaning.
• Condensation has formed. Allow the player to dry out.
• The disc is scratched. Replace the disc.
No picture • Check that you are in DVD mode if playing a DVD
Distorted picture • Check the disc for ngerprints and clean with a soft cloth,
wiping from center to edge.
• Sometimes a small amount of picture distortion may appear.
This is not a malfunction.
Cannot advance through a
movie
• You cannot advance through the opening credits and
warning information that appears at the beginning of
movies because the disc is programmed to prohibit that
action.
No sound or distorted sound • If you are using the IR headphones, make sure you turn ON
the IR transmitter on the DVD system.
• Verify that the batteries in the IR Headphones are good.
• Is volume turned “UP” on IR Headphones?
• Is anything blocking signal between the monitor and the
Headphones?
• Make sure your DVD player is connected properly. Make
sure all cables are securely inserted into the appropriate
jacks.
• The disc is loaded backwards. Turn the disc around so that
the disc is facing towards the driver.
Device feels warm • When the device is in use for a long period of time, the
surface will be heated. This is normal.
Player does not respond
to all commands during
playback
• Operations are not permitted by the disc.
• Refer to the instructions in the disc inlay.