User Manual

2mm
WARNING! Securely glue together. If coming off
during flights, you lose control of your airplane
which leads to accidents !
18- Vertical stabilizer / Seitenleitwerk
2mm
CA
A
B
1- Attach the tail gear mounting plate on the fuselage bottom
with 3x10mm self tapping screws
2- Trial fit the rudder in position, mar the mounting hole position
for the tail gear with a felt tipped pen or a pencil.
3- Remove the rudder and drill 2mm (5/64”) hole as shown.
4- Put the epoxy glue in the hole of rudder. Push the rudder in
place
2mm 2mm
WARNING! Securely glue together. If coming off
during flights, you lose control of your airplane
which leads to accidents !
10mm
Plastic control horn
2x20mm screw
............................2
.......................4
Plastic back plate
...........................2
When you are satisfied with the
alignment of the control horn mark
the mounting hole positions with a
felt tipped pen or a pencil.
Remove the control horn and drill
two 2mm (5/64”) holes through the
elevator
Insert the elevator push rod into the
elevator control horn. Attach the ele-
vator control horn using two 2x20mm
screw and a back plate.
Hinge
STABILIZER
A
B
Apply 5 min.
Epoxy both the
top and bottom.
ELEVATOR
17- Horizontal Tail
Hohenleitwerk
Petroleum jelly
A
B
Apply 5 min.
Epoxy both the
top and bottom.