User Manual

Cut away only the covering
both the right and left side
Trial fit the horizontal stabilizer in place .
Check the alignment of the horizontal
stabilizer. When you are satisfied with the
alignment, use a pencil to trace around the top and
bottom of the stabilizer where it meets the fuselage.
7-Horizontal Stabilizer
Remove the horizontal stabilizer
from the vertical stabilizer. Using a straight edge
and a sharp hobby knife, carefully cut away
the covering inside the lines which were marked
above. Be cautious not to cut into the wood-this
will weaken the structure.
Again, slide the horizontal stabilizer into the
slot on the fuselage. Check the alignment of the
horizontal stabilizer. When you are satisfied with
the alignment, glue the both sides of the horizontal
stabilizer where it meets the fuselage.
A
A’
B
B’
A=A’ B=B’
! Securely glue together. If coming off during fly,
you lose control of your air plane.
Cut away only the
covering both sides.
CA