Specifications

11
Setup
Connection using a FireWire cable
MIDI and audio settings on your computer
If you want to use the M3 Editor / Plug-In Editor to handle MIDI and audio data from an M3
equipped with the EXB-FW option (sold separately) and connected to your computer via a
FireWire cable, you’ll need to make system settings on your computer so that the computer
system does not occupy those ports. You must also make audio input/output device settings
for your host application to avoid damaging the speakers etc. that are connected to your com-
puter. (☞p.19)
Windows
1 Disconnect the FireWire cable between your M3 and computer.
2 From the Control Panel, start up “Sounds and Audio Devices.” The Sounds and Audio
Devices Properties dialog box will appear.
3 Click the Audio tab.
4 The current sound playback device is selected as the default device for sound
playback. The current sound recording device is selected as the default device for
sound recording.
The current MIDI playback device is selected as the default device for MIDI music
playback.
In this state, select the “Use only default devices” check box located at the very
bottom, and click the [Apply] button to save these settings. The “Use only default
devices” setting is enabled, and the M3 port will not be selected as a “default device.”