Instruction Manual

10
HDMI Game Stick
1. Interrupt the power supply by unplugging the USB A Connector end
of the Micro USB Power Cable from the USB port on your television
or other qualified DC 5V adapter with output no less than 500mA.
2. Unplug the HDMI Game Stick from the HDMI port on your television.
3. Wait for 10 Seconds, then plug the HDMI Game Stick into the HDMI
port on your television.
4. Plug the USB A Connector end of the Micro USB Power Cable into
the USB port on your television or other qualified DC 5V adapter
with output no less than 500mA. The unit will now be ready to
play again.
Wireless Controller
1. Interrupt the power supply by removing the batteries.
2. Let the unit stand for 10 seconds, then replace the batteries.
3. The unit will now be ready to play again.
4. If the unit still does not work, replace with an entire set of
new batteries.
OTHER NOTES
Static electricity may cause the HDMI Game Stick to malfunction. In cases
where the HDMI Game Stick is malfunctioning due to static electricity,
disconnect the Micro USB Power Cable, wait for 10 seconds, then
reconnect the Micro USB Power Cable to reboot the HDMI Game Stick.
FCC Compliance Statement
After completing the steps in the Initial Setup section, power on the
television. FCC e-labeling will be shown on the television for the U.S.
version of LeapLand Adventures™.
This screen confirms that this product complies with FCC regulations.