Instruction Manual

3
Unlock the Packaging Locks
Rotate the packaging locks 90 degrees
counterclockwise.
Pull out the packaging locks and discard.
GETTING STARTED
INITIAL SETUP
1. Plug the USB B Connector end of the Micro USB
Power Cable into the USB B port on the HDMI
Game Stick.
2. Plug the HDMI Game Stick into an HDMI port on
your television.
3. Plug the USB A Connector end of the Micro USB
Power Cable into a USB port on your television
or other qualified DC 5V adapter with output no
less than 500mA.
BATTERY REMOVAL AND INSTALLATION
1. Find the battery cover located on the back of the
Wireless Controller, use a coin or screwdriver to
loosen the screw and then open the battery cover.
2. Remove old batteries by pulling up on one end
of each battery.
3. Install 2 new AA (AM-3/LR6) batteries following
the diagram inside the battery box.
4. Replace the battery cover and tighten the screw
to secure.