User's Manual
56
Conguring the Phone
Setting the date and time (continued)
To set the time format:
1. From the Date & Time menu, ensure that Clock Time is highlighted.
2. Press t or u to select a 12-hour clock (12am/pm) or 24-hour clock.
3. Press
Save
.
To set the date format that appears on the idle screen:
1. From the Date & Time menu, press q to highlight Clock date.
2. Press t or u to select the desired date format (DD/MM/YY, MM/DD/YY, YY/
MM/DD)
3. Press
Save
.
To set the Time Zone:
1. From the Date & Time menu, press q to highlight Time Zone.
2. Press
Edit
.
3. Press p or q to select a setting. The time zone is set as an offset from GMT.
For example, EST is -5, and PST is -8.
4. Press
Save
.
To enable or disable Daylight Savings Time adjustment:
1. From the Date & Time menu, press q to highlight DST.
2. Press t or u to select Enabled or Disabled.
3. Press
Save
.
To enable or disable the NTP (Network Time Protocol) server:
1. From the Date & Time menu, press q to highlight NTP server.
2. Press t or u to select Enabled or Disabled.
3. Press
Save
.
Note: If the NTP server is disabled, you must manually set the time and date.
This setting is valid only if the system administrator has already congured
the Network Time settings. For more information, see the VSP726 Deskset
Administrator and Provisioning Guide.
To congure the NTP Server:
1. From the Date & Time menu, press q to highlight NTP and then press
Edit
.
2. On the NTP menu, enter the URL of the NTP server. Press the
ABC
key to
switch between entering upper case letters, lower case letters, and numbers.
3. Press
Save
.