User Guide

EN - 10
Installation
SIP Next Gen Corded 1-line Hotel
Telephone - NG-S3211
SIP Next Gen Corded 1-line Wi-Fi
Enabled Hotel Telephone - NG-S3211W
Telephone base installation
1. Connect both the ethernet cable and coiled
handset cord to the telephone base and route
them along the wire ducts accordingly. Install
the telephone base as shown below.
~
~
2. If you are connecting a power adapter,
make sure it is securely plugged into an outlet
not controlled by a wall switch, and the ethernet
cable is plugged into the network wall jack.
• NOTE: Power adapter is not required for
Power over Ethernet (PoE).
3. Press on the telephone base. Listen for a
dial tone, and then press again to hang up.
Note
• The dial tone will not be played if the SIP
account used by this telephone cannot be
registered.
• The power adapter is sold separately.
• Use only the power adapter described in
“Technical specifications” on page 26.
CAUTIONS
Use only the supplied ethernet cables. The
supplied ethernet cables are not designed for
use in any other IT devices. Misusing them on
your other IT devices shall be prohibited. To
order a replacement, call 1-888-907-2007.
Installation option - desktop position
To mount the telephone base on the base
stand
1. Align the grooves of the base stand with
the telephone base.
2. Slide the base stand up to secure it.
To unmount the base stand
Simply slide the base stand down, and lift it
from the telephone base.