Instruction Manual

Appendix

Expand your telephone system

The handsets provided with your telephone system are pre-registered. Each

handset is assigned a number that shows on the handset display. Additional

handsets registered to the telephone system are assigned in sequential

order. For instance, if the telephone system already has HANDSET 1 and

HANDSET 2, the new registered handset is assigned HANDSET 3. This

telephone system accommodates up to 12 handsets.

Add and register a handset (optional)

You can add new handsets (CS6209, purchased separately) to your

telephone system, but each handset must be registered with the telephone

base before use. When rst purchased, each expansion handset shows NOT

REGISTERED.

To make registration easier, read all of the instructions on this page

before you begin. If the handset screen does not show LOW BATTERY or

HANDSET X, you will need to charge the handset for at least ve minutes

before registering to the telephone base.

To register a handset:

Place the unregistered handset in the telephone base or charger. If PRESS

FIND HS 4 SEC ON BASE does not appear on the handset screen after

a few seconds, remove the handset and place it in the telephone base or

charger again.

On the telephone base, press and hold FIND HANDSET for about four

seconds (until the red IN USE light on the telephone base turns on) and

then release the button. The handset shows PLEASE WAIT... and it

takes about 10 seconds to complete the registration. The handset shows

HANDSET X REGISTERED (X represents the handset number assigned)

and you hear a beep when the registration completes.

If the registration fails, the handset shows NOT REGISTERED. To reset the

handset, remove the handset from the telephone base and place it back in.

Try the registration process again.

You cannot register a handset if any other system handset is in use.