User`s manual

Dialing keys
Enter numbers or
characters.
Answer an incoming
call.
Quick start guide (Canada version)
CS6449/CS6449-2/CS6449-3
Introduction
This quick start guide provides you with the basic installation
and use instructions. A limited set of features are described in
abbreviated form.
Please refer to the user’s manual for complete installation and
operation instructions.
Telephone base and handset charger installation
Install the telephone base and handset charger as shown below.
Handset battery installation and charging
Install the battery as shown below. Once you have installed the battery,
you may be able to make and receive short calls. For best performance,
charge the handset battery continuously for at least 11 hours.
Plug the battery connector
securely into the socket
inside the handset battery
compartment, matching the
color-coded label.
1.
Place the battery with the
label THIS SIDE UP facing
up and the wires inside the
battery compartment.
2.
Align the cover flat against the
battery compartment, then
slide it towards the center of the
handset until it clicks into place.
3. Charge the handset by
placing it in the handset
charger. The CHARGE light
is on when the handset is
charging.
4.
CHARGE light
On when the handset is
charging.
MUTE/DELETE
Mute the microphone
during a call.
Delete the displayed entry
while in the directory, call
log or redial list.
Silence the ringer
temporarily while the
handset is ringing.
Delete digits or characters
while using the dialing keys.
/FLASH
Make or answer a call.
Answer a call waiting call
during a call.
1
Press repeatedly to add
or remove 1 in front of
the call log entry before
dialing or saving it to the
directory.
OFF/CANCEL
Hang up a call.
Silence the ringer
temporarily while the
handset is ringing.
Press and hold to delete
the missed call indicator
while the handset is not
in use.
Press to return to the
previous menu, or
press and hold to return
to idle mode without
making changes.
Dialing keys
Enter numbers or
characters.
Answer an incoming call.
# (pound key)
Press repeatedly to
show other dialing
options when reviewing
a call log entry.
CID/ /VOLUME (caller ID)
Review the call log when the
handset is not in use.
Scroll down while in a menu.
Decrease the listening volume
during a call or message
playback.
Move the cursor to the left when
entering numbers or names.
/ /VOLUME (directory)
Review the directory when
the handset is not in use.
Scroll up while in a menu.
Increase the listening volume
during a call or message
playback.
Move the cursor to the right
when entering numbers or
names.
INT
Initiate or answer an intercom
call, or to transfer a call.
REDIAL/PAUSE
Press to review the redial list.
Press and hold to insert a dialing
pause while entering numbers.
(Speakerphone)
Make or answer a call using the
handset speakerphone.
Switch between the
speakerphone and the handset
during a call.
TONE
Switch to tone dialing
temporarily while on a call.
Handset overview
MENU/SELECT
Show the menu.
Choose an item, or save an
entry or setting while in a
menu.
®
Telephone
line cord
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required.
Telephone base
power adapter
Telephone base
Charger
Electrical outlet not
controlled by a wall
switch
Charger adapter
Telephone
wall jack
CHARGE light
remains on when
charging.
IN USE light
On when the phone is in use, or
when the answering system is
answering an incoming call.
On when a handset is being
registered.
Flashes when there is an
incoming call.
Flashes when the handsets are
being deregistered.
Flashes when another telephone
is in use on the same line.
FLASH
Answer a call waiting call
during a call.
MENU/SELECT
Show the menu.
Choose an item, or save an entry or setting while
in a menu.
CANCEL
Silence the ringer temporarily while
the telephone base is ringing.
Press and hold to delete the
missed call indicator while the base
is not in use.
Press to return to the previous menu,
or press and hold to return to idle
mode without making changes.
CID (caller ID)
Review the call log when
the base is not in use.
Scroll down while in a
menu.
Move the cursor to
the left when entering
numbers or names.
FIND HANDSET
Page all system
handsets.
Review the directory when the base is
not in use.
Scroll up while in a menu.
Move the cursor to the right when
entering numbers or names.
INT
Initiate or answer an
intercom call, or to
transfer a call.
1
Press repeatedly to add or
remove 1 in front of the call log
entry before dialing or saving it
to the directory.
Telephone base overview
TONE
Switch to tone dialing
temporarily while on
a call.
MIC
Microphone.
MUTE
Mute the microphone during a call.
Silence the ringer temporarily while
the telephone base is ringing.
VOL
Adjust the listening
volume during a call or
message playback.
Adjust the telephone
base ringer volume when
the base is not in use.
REDIAL/PAUSE
Press to review the redial list.
Press and hold to insert a dialing
pause while entering numbers.
/SPEAKER
Make, answer or end
a call.
Switch between the
base speakerphone and
the corded handset.
/ANS ON/OFF
Turn the answering system
on or off.
/PLAY/STOP
Play messages.
Stop message playback.
Flashes when there are new messages
or memos in the answering system.
X/DELETE
Delete the playing
message.
Press twice to delete
all old messages
when the base is not
in use.
Delete digits or
characters while using
the dialing keys.
Delete the displayed
entry while in the
directory, call log or
redial list.
/REPEAT
Repeat a message or press twice
to play the previous message.
/SKIP
Skip to the next
message.
Using the menu
To enter the menu:
Press MENU/SELECT when the telephone is not in use.
Press or until the screen displays the desired feature menu.
Press MENU/SELECT to enter that menu.
To return to the previous menu, press OFF/CANCEL on the
handset or CANCEL on the telephone base.
To return to idle mode, press and hold OFF/CANCEL on the
handset or CANCEL on the telephone base.
Telephone settings
Default settings are indicated by asterisks (*).
1.
2.
3.
•
•
Screen display Function Options
LCD language Set the screen display language. English*
Français
Espaňol
Clr voicemail Turn off the voicemail indicators. Turn off
indicator?
Key tone Turn the key tone on or off. On*
Off
Set date/time Set the date and time for the
telephone, or enable the date and
time to be set by incoming caller
ID information.
Date & time
CID time sync
Home area code Enter your home area code if you
dial only seven digits for local calls.
_ _ _
Dial mode Set the telephone to be tone or
pulse dialing.
Tone*
Pulse
Set date and time
Press MENU/SELECT when the telephone is not in use.
Scroll to >Settings, then press MENU/SELECT.
Scroll to >Set date/time, then press MENU/SELECT.
Press MENU/SELECT to select >Date & time.
Use the dialing keys (0-9) to enter the month, date and year, and
then press MENU/SELECT to move on to set the time.
Use the dialing keys (0-9) to enter the hour and minute.
Press or to select AM or PM, or press 2 for AM or 7 for PM.
Then press MENU/SELECT to save.
Ringer volume
Press MENU/SELECT when the phone is not in use.
Scroll to >Ringers, then press MENU/SELECT.
Press MENU/SELECT to select >Ringer volume.
Press or to sample each volume level, then press
MENU/SELECT to save.
Telephone operation
Make a call
Using a cordless handset:
Press /FLASH or , and then dial the telephone number.
-OR-
Enter the telephone number and then press /FLASH or
to dial.
Using the telephone base:
Lift the corded handset or press /SPEAKER on the telephone
base, and then dial the telephone number.
-OR-
Enter the telephone number, then press /SPEAKER or lift the
corded handset to dial.
Answer a call
Using a cordless handset:
Press /FLASH, or any dialing key.
Using the telephone base:
Lift the corded handset, or press /SPEAKER or any dialing key.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
•
•
•
•
•
•