® User’s manual Accessory handset for use with VTech models DS6421/DS6472 w w w .v t e c h p h o n e s .
Congratulations on purchasing your new VTech product. Before using this telephone, please read Important safety instructions on page 9 of this manual. This manual has instructions how to set up and register your new handset. For complete instructions on using the handset, see the user’s manual that came with your telephone base. If you cannot find your user’s manual, you can view or download it at www.vtechphones.com. For support, shopping and everything new at VTech, visit our website at www.vtechphones.
Table of contents Getting started..........................................................................1 Parts checklist............................................................................ 1 Battery installation .................................................................... 2 Battery charging......................................................................... 3 Add and register a handset........................................................ 4 Deregister handsets.....................
Getting started Parts checklist Your telephone contains the following items. Save your sales receipt and original packaging in the event warranty service is necessary. User’s manual Battery Charger and power adapter Battery compartment cover Handset To purchase a replacement battery or power adapter, visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial 1 (800) 267-7377.
Getting started Battery installation Install the battery as shown below. 1. Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label. 2. Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment. 3. Align the cover flat against the battery compartment, then slide it towards the center of the handset until it clicks into place. 4. Charge the handset by placing it in the telephone base or charger.
Getting started Battery charging Once you have installed the battery, the handset LCD display indicates the battery status (see the table below). • For best performance, keep the handset in the telephone base or charger when not in use. • The battery is fully charged after 16 hours of continuous charging. • If you place the handset in the telephone base or the charger without plugging in the battery, the screen displays No battery.
Getting started Add and register a handset You can add new handsets (DS6401, purchased separately) to your telephone system, but each handset must be registered with the telephone base before use. When first purchased, each expansion handset shows Put handset on BASE to register after a battery is installed. You may need to charge the handset before registering it to the telephone base. For more details on battery charging, see the table on page 3. To register a handset: 1.
Getting started Deregister handsets If you want to replace a handset or reassign the designated handset number of a registered handset, you must deregister all handsets. Then register each handset you wish to use individually. To make deregistration easier, read all of the instructions on this page before you begin. To deregister all handsets: 1. Make sure that all handsets are out of the telephone base and handset chargers before you begin deregistration. 2.
Getting started Handset layout CHARGE light On when the handset is charging in the telephone base or charger. Softkeys (2) Press to select a menu item displayed above the key. While in a menu, press to select an item, or save an entry or setting. /CELL Press to make or answer a cell call. During a cell call, press to answer an incoming call when you hear a call waiting alert. Flashes quickly when there is an incoming cell call. Flashes slowly when a cell call is on hold.
Getting started Handset layout (continued) VOL/ / While in a menu, press to scroll up. During a call or message playback, press to increase the listening volume. When the handset is not in use, press to enter the directory. When entering numbers and names in the directory, press to move the cursor to the left. MUTE/DELETE While on a call, press to mute the microphone. While reviewing the caller ID log, directory or redial list, press to delete an individual entry. Press to delete digits when predialing.
Getting started Handset layout (continued) PUSH TO TALK (PTT) Press to begin a one-to-one or one-to-group broadcast. Press and hold to begin a broadcast to a group of handsets when the handset is not in use.
Appendix Important safety instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a dry non-abrasive cloth for cleaning. 4.
Appendix Battery • • • • • CAUTION: Use Only Supplied Battery. Do not dispose of the battery in a fire. Check with local waste management codes for special disposal instructions. Do not open or mutilate the battery. Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed. Exercise care in handling batteries in order not to create a short circuit with conductive materials.
Appendix Remember that electrical appliances can cause serious injury if used when you are wet or standing in water. If the telephone base should fall into water, DO NOT RETRIEVE IT UNTIL YOU UNPLUG THE POWER CORD AND TELEPHONE LINE CORD FROM THE WALL. Then remove the telephone by the unplugged cords. About cordless telephones • Privacy: The same features that make a cordless telephone convenient create some limitations.
Appendix FCC, ACTA and IC regulations (continued) If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents. For repair procedures, follow the instructions outlined under the Limited warranty. If this equipment is causing harm to the telephone network, the telephone service provider may temporarily discontinue your telephone service.
Appendix California Energy Commission battery charging testing instructions This telephone is set up to comply with the energy-conserving standards right out of the box. These instructions are intended for California Energy Commission (CEC) compliance testing only. When the CEC battery charging testing mode is activated, all telephone functions, except battery charging, will be disabled.
Appendix For C-UL compliance only Mesures de sécurité importantes Afin de réduire les risques d’incendie, de blessures corporelles ou d’électrocution, suivez toujours ces mesures préventives de base lorsque vous utilisez votre téléphone : 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Lisez et comprenez bien toutes les instructions. Observez toutes les instructions et mises en garde inscrites sur l’appareil. Débranchez ce téléphone de la prise murale avant de le nettoyer.
Appendix For C-UL compliance only 14. N’utilisez pas le téléphone pour rapporter une fuite de gaz à proximité de la fuite. En certaines circonstances, une flammèche pourrait être provoquée lorsque l’adaptateur est branché à une prise de courant, ou lorsque le combiné est déposé sur le socle. Ceci est un événement commun associé à la fermeture d’un circuit électrique.
Appendix For C-UL compliance only À propos des téléphones sans fil • Alimentation électrique: Les mêmes caractéristiques qui constituent des avantages pour les téléphones sans fil affichent également des restrictions. Les appels téléphoniques sont transmis entre le combiné sans fil et le socle par le biais d’ondes radio ; il y a donc la possibilité que vos conversations téléphoniques sans fil soient interceptées par des équipements de réception radio se trouvant dans la portée du combiné sans fil.
Appendix Limited warranty What does this limited warranty cover? The manufacturer of this VTech Product warrants to the holder of a valid proof of purchase (“Consumer” or “you”) that the Product and all accessories provided in the sales package (“Product”) are free from defects in material and workmanship, pursuant to the following terms and conditions, when installed and used normally and in accordance with the Product operating instructions.
Appendix Limited warranty (continued) How do you get warranty service? To obtain warranty service in the United States of America, please visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial 1 (800) 267-7377. NOTE: Before calling for service, please review the user’s manual - a check of the Product’s controls and features may save you a service call.
Appendix FCC, ACTA and IC regulations FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation.
Appendix Technical specifications Frequency control Crystal controlled PLL synthesizer Transmit frequency Handset: 1921.536-1928.448 MHz Telephone base: 1921.536-1928.448 MHz Channels 5 Nominal effective range Maximum power allowed by FCC and IC. Actual operating range may vary according to environmental conditions at the time of use. Power requirements Handset: 2.
® The Bluetooth word mark and logos are owned by Bluetooth SIG, Inc. and any use of such marks by VTech Holdings Limited is under license. VTech Holdings Limited is a member of Bluetooth SIG, Inc. Other trademarks and trade names are those of their respective owners. Designed to fit your home. And your life. VTech Communications, Inc. A member of THE VTECH GROUP OF COMPANIES. VTech is a registered trademark of VTech Holdings Limited. Specifications are subject to change without notice.
