Safety Information

If Phone is dead -

1. Please ensure that the cords (power and telephone line) are plugged into

the channels on the bottom of the base. If the cords are not properly

installed, the base will not sit level and the phone may not charge properly.

2. Please make sure the battery cover is on properly and flush with the

handset. If there are any spaces or gaps around the battery cover, the unit

may not charge properly.

3. To determine if the handset or the battery is defective, swap the

batteries with a known working handset. Ensure that the customer fully

charges the battery and monitors it. If the issue follows the handset,

replace the handset if the system is expandable. Replace the whole system

if the system is non-expandable.

4. Confirm proper installation of the telephone base power supply and

handset battery. You should only use the power supply provided with your

telephone. Make sure the power supply is not connected to an electrical

outlet that is controlled by a wall switch. Confirm that the electrical outlet

that the telephone is plugged into is working.

5. When charging your cordless phone for the first time, or when the

battery is completely dead, after 30 minutes of uninterrupted charging, the

handset will be fully functional; which includes the handset display and

indicator lights. There is enough charge at this point to use the telephone

for a short time.

If no dial tone

1. When placing the handset in the charging base, confirm that the charge

contacts on the handset and base are making a good connection. The

CHARGE light on the handset will be on when the handset is charging.

You should allow 16 hours to fully charge the handset battery. For optimum

daily performance, return the handset to its telephone base when not in

use.

2. Make sure that the power cord is securely plugged into the base and

electrical outlet. Make sure the electrical outlet is not controlled by a wall

switch.

3. Check the installation of the unit. Make sure the telephone line cord is

connected from the base unit to a telephone jack. If the cord is already

plugged in, unplug the cord at both ends and reconnect.

4. Move the handset closer to the base. The operating range may vary with

PAGE 1
If Phone is dead 1. Please ensure that the cords (power and telephone line) are plugged into the channels on the bottom of the base. If the cords are not properly installed, the base will not sit level and the phone may not charge properly. 2. Please make sure the battery cover is on properly and flush with the handset. If there are any spaces or gaps around the battery cover, the unit may not charge properly. 3.
PAGE 2
environmental conditions and time of use. There may be places within your environment that a cordless phone will not work well. If the problem only occurs in certain areas of your environment, you can conclude that there is nothing wrong with the phone. 5. If the handset is not responding normally, you may need to reset your telephone system. Complete the following steps to reset the telephone system: Step 1: Disconnect the power to the telephone base. Step 2: Disconnect the handset battery(s).