User`s manual

4
IMPORTANT INFORMATION
Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com, or call
1 [phone]. In Canada, dial 1 [phone].
The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
1.
2.
Telephone base installation
Install the telephone as shown below. The telephone base is ready for
table use.
4. Plug the large
end of the AC
power adapter
into a power
outlet not
controlled by a
wall switch.
2. Plug the small end
of the AC power
adapter into the
power jack at the
bottom of the
telephone base.
1. Plug one end of
the telephone
line cord into the
telephone jack at
the bottom of the
telephone base.
If you have DSL high
speed Internet service, a
DSL filter (not included)
is required.
5. Plug the other
end of the
telephone line
cord into a
telephone jack
or a DSL filter.
3. Route the power
adapter cord
through the slot.
Telephone line cord