User`s manual

47
The answering
system does
not answer
after the correct
number
of rings.
Make sure that the
answering system is on.
If toll saver is activated,
the number of rings
changes to two when
you have new messages
stored.
If the memory is full or the
system is off, the system
will answer after 10 rings.
If you subscribe to
voicemail service, change
the number of rings so
that your answering
system answers before
your voicemail answers.
To determine how
many rings activate
your voicemail, contact
your telephone service
provider.
The answering
system does
not record
messages.
Make sure the answering
system is on. When the
answering system is on,
ANS ON should display
on the handset and the
telephone base.
When the answering
machine memory is full,
it does not record new
messages until some old
messages are deleted.
If you subscribe to
voicemail service, change
the number of rings so
that your answering
system answers before
your voicemail service
answers. To determine
how many rings activate
your voicemail service,
contact your telephone
service provider.
The answering
system does
not announce
the correct day
of the week
for recorded
messages time
stamp.
Make sure you have
set the date and time.
See !"#$%&'()!%&(
telephone section.
The messages
on the
answering
system are
incomplete.
If a caller leaves a very
long message, part of
it may be lost when
the answering system
disconnects the call after
the preset recording time.
If the memory on the
answering system
becomes full during a
message, the answering
system stops recording
and disconnects the call.
If the callers voice is
very soft, the answering
system may stop
recording and disconnect
the call.
The answering
system does
not respond
to remote
commands.
Make sure you enter the
correct remote access
code.
Make sure you are
calling from a touch-tone
telephone. When dialing a
number, there should be
tones. If there are clicks,
then it is not a touch-tone
telephone and cannot
activate the answering
system.
The answering system
may not detect the remote
access code when
your announcement is
playing. Wait until the
announcement is over
before entering the code.
I accidentally
set my LCD
language to
Spanish or
French, and I
dont know how
to change it
back to English.
While the handset is
not in use, press MENU
and then enter
364# to
change the handset LCD
language back to English.