User`s manual

5
Getting started
Install the telephone base and charger as shown below. If you subscribe
to high-speed Internet service (DSL - digital subscriber line) through your
telephone line, you must install a DSL filter between the telephone line cord
and the telephone wall jack. The filter prevents noise and caller ID problems
caused by DSL interference. Please contact your DSL service provider for more
information about DSL filters.
The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, refer to Wall mount installation on page 8 for details.
Telephone base and charger installation
IMPORTANT INFORMATION:
Use only the power adapters provided with this
product. To obtain a replacement, visit our website
at www.telephones.att.com or call
1 [phone]. In Canada, dial
1 [phone].
Raise the antenna.
Plug the large end
of the smaller power
adapter into an
electrical outlet not
controlled by a
wall switch.
Ensure the small end
of the smaller power
adapter is plugged into
the power jack on the
back of the charger.
Route the cord through
the slot.
Telephone line cord
DSL filter (not included)
is required if you
have DSL high-speed
Internet service.
Telephone wall jack
Electrical outlet not
controlled by a wall
switch
Plug the small end
of the larger power
adapter into the power
jack on the back of the
telephone base.
Plug the large end
of the larger power
adapter into an
electrical outlet not
controlled by a wall
switch.
Plug one end of the
telephone line cord
into the TEL. LINE jack
on the back of the
telephone base.
Plug the other end of
the telephone line cord
into a telephone wall
jack.
Route the cords
through the slot.