User`s manual

Telephone settings

Number of rings

You can set the answering system to answer an incoming call after two, four

or six rings. You can also select toll saver, which is explained below. Unless

you change it, the answering system answers an incoming call after four rings.

To set the number of rings:

Press MENU/SELECT when in idle mode.

Press DIR or CID to scroll to >Answering sys, then

press MENU/SELECT.

Press DIR or CID to scroll to >Ans sys setup. Press

MENU/SELECT.

Press DIR or CID to scroll to ># of rings, then press MENU/SELECT.

Press DIR or CID to scroll and choose among 2, 4, 6 or Toll saver.

Toll saver - the answering system answers a call after two rings if

you have new messages, and after four rings when there are no new

messages. This feature allows you to check for new messages and avoid

paying long distance charges if you are calling from out of your local area.

Press MENU/SELECT to confirm your setting. A confirmation tone sounds.

NOTE: If you subscribe to a voicemail service offered through your telephone service

provider, see About answering system and voicemail on page 50.

Remote access code

To access your answering system remotely from any touch-tone telephone,

you need to enter a two-digit number (00-99). Unless you change it, the

remote access code is 19.

To change the remote access code:

Follow steps 1 through 3 in Number of rings on this page.

Press DIR or CID to scroll to >Remote code, then

press MENU/SELECT.

Press DIR or CID to select the remote access code, or

use the dial pad keys to enter a desired number (00-99).

Press MENU/SELECT to confirm your setting. A

confirmation tone sounds.

NOTE: For more details about the remote access feature, refer to Remote access on page 58.

•

Answering system settings

Remote code

# of rings