User Guide

46
47
remote access code (19 is the default
code).
• The system automatically
announces the number of new or
old messages (if any), and then
begins to play them.
You can also enter the following remote
commands.
Commands Description
1 Press to listen to all messages.
2 Press to listen to new messages
only.
3 Press to delete the current
message (during playback).
33 Press twice to delete all old
messages.
4 Press to repeat the current
message (during playback).
44 Press twice to listen to the previous
message.
5 Press to stop.
*5 Press to listen to a list of remote
commands.
6 Press to skip to the next message
(during playback).
*7 Press to record a new
announcement.
8 Press to hang up the call.
0 Press to turn the answering system
on or off.
3. Hang up or press 8 to end the call.
NOTES
• If you do not enter a valid remote
access code, the system answers the
call automatically.
• Once the messages have played, the
telephone announces the help menu
options. If you do not press any key
with 20 seconds, the remote access
call ends automatically.
• If the memory is full, the answering
system answers after 10 rings and
announces, “Memory is full. Enter
the remote access code.” Enter your
remote access code to access the
messages and announcements.
• When the answering system is turned
off, the telephone answers after 10
rings, and announces, “Please enter
your remote access code.”
Call intercept while using answering
system
When a caller is leaving a message
on your answering system, you can
stop recording and talk to the caller by
pressing
or on the handset.
Recording memo
1. Press MENU/SELECT in idle mode.
2. Press
p/q to highlight Answering
sys, then press MENU/SELECT.
3. Press
p/q to highlight Record memo,
then press MENU/SELECT. The system
announces, “Record after the tone.
Press 5 when you are done.” Speak
towards the handset microphone.
4. Press 5 to stop recording. The system
announces, “Recorded.” and then
returns to the previous menu. The
system does not save memos shorter
than two seconds.
Turn on or off the call screening
Use this feature to choose whether
incoming messages can be heard over
the telephone base when they are being
recorded. If you turn call screening on,
you hear the incoming message.
1. Press MENU/SELECT in idle mode.
2. Press
p/q to highlight Answering
sys, then press MENU/SELECT .
3. Press
p/q to highlight Ans sys setup,
then press MENU/SELECT twice to
select Call screening.
4. Press
p/q to choose between On
and Off, then press MENU/SELECTto
save.
Screen a call with answering system
Screen calls at the cordless handset
If the answering system is on and a call
is being answered by the answering
system, the handset shows To screen
call press [SELECT] at the same time.
Press MENU/SELECT to screen the call
on your handset. The handset shows
the caller’s information. If you do not
subscribe to caller ID service, the
handset shows Screening....
Options while a message is being
recorded
• Press
p/VOLUME/q on the
handset to adjust the call screening
volume.
• Press
to switch between
speakerphone mode and handset
mode.
• Press
to answer the call.
Screen calls at the base
If the answering system and call
screening are on, the announcement
and the incoming
message broadcast at the telephone
base when a call is answered by the
answering system.
Options while a message is being
recorded
• Press - VOL + on the telephone
base to adjust the call screening
volume.
• Press
to temporarily turn
on the call screening if the call
screening is set to off.