Specifications
MAKING CALLS
You can make calls directly from the
handset whether you are at the base
'
or away from it.
NOTE: There are two different ways
to dial
a
number:
1. Press the
(-E)
key and wait
for dial tone. Then dial the number
you want.
2. Enter the number onto the display
first, then press the
(PHONE)
key.
This will dial the number that is
displayed on the LCD after
2
seconds. See "ADVANCED
DIALING" on Page 21
If you make a mistake when dialing,
press to hang up, then press
the PHONE key to get the dial tone
again.
DISCONNECTING
To end a call, either place the handset
back in the base, or press
@
on
the handset.
OFF MODE (STANDBY)
When the unit is OFF the display will
be clear.
VOLUME CONTROLS
The handset has a digital volume
control.
The volume controls for the handset
are located on the side of the unit.
Press the
A
(up) or
Q
(down) keys
to increase of decrease the volume.
Holding either key down will
continuously change the volume setting.
The ear piece volume level indicator
will change accordingly.
FLASH
You can use your Vtech VT 191
1
cordless phone with services such as
Call Waiting. Instead of pressing the
switch-hook (as you would on a regular
phone) press the
(PHONE)
key.
REDIAL
To REDIAL the last number you dialed,
(P~E)
key, then press
The phone will automatically
dial the number. The number will be
shown on the display.
CLEARING THE DISPLAY
The display can be cleared by pressing
and holding the CLEAWDEL key down
until the display clears.
MUTE
Press
(ME)
on the handset
to disable the handset microphone.
Press
(MUTE)
again to return to
normal operation.
0
RINGER MUTE
Press on the handset
during incoming ringing will disable
the ringer for the duration of the
call.
I!'.
I
I
CID WITH CALL WAITING
If during amormal phone call another
call comejs in with CID information,
notificatiop beeps will be heard in the
The newl;~~~ information will be
displayed
on the LCD for
10
seconds
and will ti ,'en be stored in memory.
See
CID-FALLER
ID on page
25.
Switchin
'
calls
To sw !ch over to the new call,
press e phone key, the first call
is put n hold.
To sw tch back to the first call,
press
1
,fie(p=~)ke~ again.
I
[e]li
SWITCHING
CALLS
TO
SWITCH
OVER
TO
I
THE
NEW
CALL
PRESS-
TO
SWITCH BACK
TO
THE
FIRST
CALL
PRESS-
AGAIN
the call normally. Then
To end the call, press
or place
the handset back in the base. The
phone will automatically go back to
Programming The Ringer
The handset ringer is capable of four
different types of ringer tones
. The
following section details how to select
different ringer types and how to turn
off the handset ringer.
rotary (dial-pulse) servide.-
Changing Ringer Types
To program, the handset must be
OFF.
tl
[E)
@=-1
To select a different ringer type do the
TEMPORARYTONE
DIALYOUR
CALL
NUMBER
following:
H
om@
TYPES
PRESS
PRESS
@
PRESS@@@
e)aED-
m
Q
-a-
-
PRESS
n
n
Press:
Press:
1
for ringer type
1
2
for ringer type
2
3
for ringer type
3
4
for ringer type
4
0
for ringer off (ringer disabled)
Temporary Tone