Specifications

USING THE WALL MOUNT
ADAPTOR
1. Position the wall mount bracket
on the base.
Line up the tabs on the wall mount
adaptor with the holes on the
bottom of the base (Figure
1).
Snap the wall mount bracket firmly
in place.
-
3
Figure 1
LCD Messages
i:
i 1
is displayed when the handset
microphone has been muted.
2. Mount the base on the wall.
Position the base so the mounting
studs will fit into the holes on the
bottom of the base. Position the
power cord to extend down the wall
the phone is to be mounted on.
Slide the base down on the
mounting studs until it locks into
place.
6 J
is displayed when the handset ringer
has been muted.
The OFF
$30~ Indicator is displayed
3. Connect the telephone line cord.
The telephone line cord has a
snap-in plug at each end. Insert
one of the plugs into the jack on the
bottom of the base.
Insert the other
end of the plug into the wall jack.
---
andset volume setting.
%
is displayed when the handset has lost
communication with the base unit and
is attempting to reestablish a link by
scanning all channels.
4. Plug the ac adaptor on the
power cord into an electrical
outlet (Figure
2).
when the unit is in a low-
ition. The handset typically
at least
5 minutes after the
indication is given.
is displayed if communication with the
base is reestablished.
5. Set .the TONEIPULSE SWITCH
on the base unit.
If you have touch tone
service on
your phone line, set the switch to
TONE. If you have rotary service,
set the switch to PULSE (Figure
3).
is display
when the base pages the
handset.
is displayed while in standby mode, if
another phone is currently using the
same line.
-TONE PULSE
SELECTION
1 J
is displaydd when the handset is on
Figure
3