Operating instructions

16
party can’t hear you.
2.While the call is muted, the MUTE
indicator will be lit.
3.To go back to the two-way conver-
sation, press MUTE again.
TIPS ON USING THE VT 9141 SPEAK-
ERPHONE:
1. Adjust the Speakerphone volume
to a comfortable listening level by
pressing the VOL UP or DOWN
keys.
Y
CLEAN CHARGE
WITH AN ERASER
C
E CALL VTECH AT
-
XXX-XXXX
VOL
2 ABC 13 DEF
4 GHI 5 JKL 6 MNO
7 PQRS 8 TUV 9 WXYZ
TONE
0
OPER
2. If there is background noise in the
area where you are using the Speak-
erphone, (people talking, a radio or
television playing, for example), you
may experience some degree of
“chopping” or “dropout” as your
party speaks. To remedy this, do the
following:
* Try to lower the source of the back-
ground noise in your environment;
otherwise;
* When it’s your party’s turn to talk,
press the MUTE key. The MUTE
LED will glow. When it is your turn
to speak, press MUTE again to re-
activate the Base Unit microphone.
SWITCHING FROM THE BASE UNIT
(SPEAKERPHONE) TO THE HAND-
SET
If you are on a call using the Base Unit
(Spearkerphone) and the Handset is
in the base, you can automatically
switch from the speakerphone to the
handset by picking up the handset.
SWITCHING FROM HANDSET TO
THE BASE UNIT (SPEAKPHONE)
To switch back to the base unit (speak-
erphone), you must first press the HOLD
key on the handset, then press the
SPEAKERPHONE key on the base.
7 PQRS 8 TUV 9 WXYZ
TONE
0
OPER
HOLD
PRV
INT.COM
PGM
MEM REDIAL
PAUSE
NOTE:You cannot switch back to
the Speakerphone just by return-
ing the Handset to the Base. That
will disconnect the call.
JOINING A CONVERSATION
From Base
X-XXX-XXX-XXXX
MIC
INTERCOM
SPEAKERPHONE
VOL
4 GHI 5 JKL 6 MNO
7 PQRS 8 TUV 9 WXYZ
TONE
0
OPER
OPERATING INSTRUCTIONS