Specifications

2. Press REC/MEMO ,”Now recording”, is announced, followed by a beep. Speak towards the

front of the Answering System (max. length: 90 seconds).

3. Press any MAILBOX key to stop the recording.

4. Your outgoing message is played for you, followed by a beep.

5. To review a recorded announcement, press MENU key until “Set Outgoing Message” is

announced. Press any MAILBOX key. The current greeting is played.

6. To delete a recorded announcement, press DELETE during OGM playback. You then hear

“Outgoing Message has been erased”.

NOTE:

If your recording time is less than 2 seconds, your OGM will not be recorded, and the default

greeting will be used.

Set Security Code

The security code programmed into the Answering System is used to gain access to functions

from remote locations. The security code default setting is 50. You can select any two-digit

code, from 40 to 99.

ANSWERING SYSTEM SETUP

NOTE:

In Announce Only mode, your outgoing

announcement is repeated before hanging up.

Recording / Playing / Deleting the Out-

going Messages (OGM)

1. Press MENU until the desired item

(Set Outgoing Message) is announced.

1. Press MENU unitl you hear “Set security

code.”

2. Press TIME/SET to hear the current

security code.

3. Press SELECT briefly to increase the

security code by 1. Or, hold SELECT

continuously to increase the code by

multiples of 10.

4. Press TIME/SET to confirm your choice

and you will hear the announcement of

the security code.

Itad Operation