Instructions / Assembly

ManualsBrandsVuelta ManualsBike Parts & AccessoriesSteel Chainring Bolt Set 8 mm Double (5-Pack)

Removing the Sensors

Procedure for Removing the Chainring

Procedure for Replacement

•

Be careful that you do not lose the screws that you remove.

Remove the crank set from the bicycle.

Refer to the documentation for the crank set regarding how to remove it.

Remove the three screws for fastening the right transmitter to the chainring adapter.

Remove the chainring adapter.

Remove the inner and outer chainrings from the crank set.

Remove the chainrings carefully so as not to damage the right transmitter and the junction cable.•

Removing the chainrings by force may cause the disconnection of the junction cable because the right transmitter is pulled strongly.•

Refer to the documentation for the crank set regarding how to remove the chainrings.

When removing the chainrings, take care not to disconnect the junction cable.

Summary of content (4 pages)

PAGE 1
Procedure for Removing the Chainring Procedure for Replacement • Be careful that you do not lose the screws that you remove. 1 Remove the crank set from the bicycle. Refer to the documentation for the crank set regarding how to remove it. 2 Remove the three screws for fastening the right transmitter to the chainring adapter. Removing the Sensors 3 Remove the chainring adapter. 4 Remove the inner and outer chainrings from the crank set.
PAGE 2
Assembling the Chainring and Installing the Right Transmitter Install the right transmitter on the right crank as you assemble the chainring. The Shimano FC-9000 is used as an example in this explanation. If the chainring and chainring adapter have been removed, assemble the chainring and fasten the right transmitter according to the following procedure. • Refer to the instruction manual for the crank set you are using for the procedure to assemble the chainring.
PAGE 3
Assembling the Chainring and Installing the Right Transmitter 2 Install the inner chainring. Install the chainring so the mark is on the crank side. Do not insert the chainring bolt at this time. Installing the Sensors 3 Install the chainring adapter. Run the junction cable along the guide of the chainring adapter, line up the bolt holes as you overlay the chainring adapter over the inner chainring (center diagram).
PAGE 4
Assembling the Chainring and Installing the Right Transmitter 5 Press on the chainring in a clockwise direction to eliminate any play as you tighten the chainring bolts to the specified torque. Tighten the chainring bolts in order 1, 2, 3, and 4 in a diagonal pattern. When doing this, do not tighten each bolt completely at one time. Gradually tighten the four bolts a little bit at a time about three times each in turn, until they all reach the specified torque.