Instructions / Assembly
4
Installing the Sensors
Assembling the Chainring and Installing the Right Transmitter
5
Press on the chainring in a clockwise direction to eliminate any play as you tighten the chainring bolts
to the specied torque.
Tighten the chainring bolts in order 1, 2, 3, and 4 in a diagonal pattern. When doing this, do not tighten each bolt completely
at one time. Gradually tighten the four bolts a little bit at a time about three times each in turn, until they all reach the
specied torque.
Tightening torque: 14 N•m•
1
2
3
4
Apply force in the direction of the arrow to eliminate play as you tighten the chainring bolts.
Refer to the instruction manual for the crank set you are using for the torque at which to tighten the chainring bolts.•
6
Install the right transmitter on the chainring adapter with the 8-mm length screws provided.
Check that the right transmitter is installed so it lines up with the chainring.
Press on the right transmitter from the outer side of the outer chainring as you insert the 3 screws, then tighten them to
the specied torque. When tightening the screws, conrm that the right transmitter is not tilted to the crank as shown in the
illustration below.
Use a tool to measure the torque when you tighten the screws.
Tightening torque: 30 cN•m•
Install the right transmitter so•
its outer circumference is on a
parallel concentric circle with
the black line on the crank. If it
is difcult to align with the outer
circumference, install it so it is
centered.
This completes the installation of the sensors on the right crank set.