Instructions / Assembly

3
Installing the Sensors
Assembling the Chainring and Installing the Right Transmitter
2
Install the inner chainring.
Install the chainring so the mark is on the crank side.
Do not insert the chainring bolt at this time.
3
Install the chainring adapter.
Run the junction cable along the guide of the chainring adapter, line up the bolt holes as you overlay the chainring adapter
over the inner chainring (center diagram).
Be sure that the chainring adapter is securely in the bolt holes, and is not riding up (right diagram).
4
Put grease on the chainring bolts and insert them into the bolt holes and temporarily install the
chainring adapter on the chainring.
Do not tighten the chainring bolts too tightly when you temporarily tighten them, allow the chainring to move.