INSTALLATION & OPERATIONAL MANUAL 1ERD & ERC SERIES ELECTRIC FRYERS With KleenScreen PLUS® Filtration Systems MODELS: 1ER50D Shown - Solid State Knob Control Secured Behind the Door ENERGY STAR® RATED 1E50BD 1ER50D 1ER50C 1E85BD 1ER85D 1ER85C 1E50BDF 1ER50DF 1ER50CF 1E85BDF 1ER85DF 1ER85CF 2E50BDF 2ER50DF 2ER50CF 2E85BDF 2ER85DF 2ER85CF 3E50BDF 3ER50DF 3ER50CF 3E85BDF 3ER85DF 3ER85CF 4E50BDF 4ER50DF 4ER50CF 4E85BDF 4ER85DF 4ER85CF 2XE5BDF 2XE50DF 2XE50CF 2XE8BDF 2XE85DF 2XE85CF ML-136730 ML-136496 ML-136
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRIC EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY………………………………………. 2 INTRODUCTION…………………………………………………………… 4 GENERAL…………………………………………………………… 4 ORDERING PARTS………………………………………………… 4 FRYER CAPACITIES………………………………………………. 4 UNPACKING………………………………………………………… 4 INSTALLATION…………………………………………………………...…… 6 CODES AND STANDARDS……………………………………….. 6 ASSEMBLY …………..…………………………………………… 6 ELECTRICAL CONNECTIONS………………………………….. 7 LEVELING THE FRYER………………………………………..
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS INTRODUCTION GENERAL Vulcan Fryers are produced with quality workmanship and material. Proper installation, usage and maintenance will result in years of satisfactory performance. Before installing the fryer, thoroughly read this manual and carefully follow all instruction. This manual is applicable to model listed on the cover page. Procedures in this manual will apply to all models unless specified.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Manual and Warranty Sample Boil Out Tablets Do not use the door or its handle to lift the fryer.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS INSTALLATION Before installing the fryer, verify that the electrical requirements agree with the specifications on the fryer data plate, which is located on the inside of the door panel. Record your fryer model, device, and serial numbers for future reference in the space provided below. This information can be found on the fryer data plate.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS The restraining device should be attached to the cutout on the back panel. See illustration for location. Australia, use only the caster supplied by the manufacturer for the fryer device. The fryer must be installed using a hose assembly restraining device to limit the movement of the appliance in accordance with AS1869. The fryer must be installed with a connector (not supplied by Vulcan) complying with the above codes.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS For 480 volt fryers a separate cord and NEMA 15-5P plug is required (not supplied with the fryer). Plug in the wire connection into an approved outlet. Place fryer as near to its final position as possible. Connect 3 phase line to X, Y and Z on terminal block. To reach terminal block, remove electric cover plate from fryer.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Before any food preparation, thoroughly wash the protective oil from all surface parts and the tank interior with hot soapy water to remove any film residue and dust or debris. Do not use chlorine or sulfate/sulfide cleaners. Wash any accessories shipped with unit. • Rinse fryer and accessories thoroughly and drain the fryer. Wipe tank completely dry with a soft, clean cloth. FILLING TANK WITH SHORTENING Close the drain valve.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Fry Basket Guidelines Do not overfill baskets. (See fry basket capacity below) Carefully lower basket into oil. When frying doughnuts and fritters, turn product only once during frying. When cooking French fries or onion rings, shake the basket several times. Batter covered foods should be dropped carefully, one by one, into shortening or basket.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Programming the Solid State Control VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Programming the Computer Control VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS TURNING OFF THE FRYER Open the door to the fryer. Press the power switch to the OFF position. EXTENDED SHUTDOWN 1. Open the door to the fryer. Press the power switch to the OFF position. 2. Thoroughly drain the fryer. Refer to DRAINING THE FRYER. 3. Clean the fryer according to CLEANING. 4. Turn off the main gas shutoff valve. FILTERING THE OIL Hot oil and hot parts can cause burns.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS 9. Fill tank with new shortening. Fill to a minimum of the MIN level but no high that halfway between MIN and MAX. Oil will expand as it is heated. 10. Press the start button only after step 9 is fully completed. The fryer will begin to heat the shortening. DRAINING THE TANK 1. Open the door to the fryer. The power must remain ON for the fryer to filter correctly. 2. Insert the drain extension into the drain valve. Tighten only hand tight. 3.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS 7. Place the drain extension in the drain valve and hand tighten only. Drain the cleaning solution from the tank into a container. 8. Close the drain valve and refill the tank with water. Add 1 cup (1/4 L) of vinegar to neutralize alkaline left by the cleaner. Solution level must be between the MIN and MAX level on the fryer tank. Press the start button to allow the solution to heat up. Allow solution to stand for a few minutes. 9.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS KleenScreen Plus® Filtration System Installation and Operational Manual for “ERF” Models 2ER50DF Shown with Accessory Casters Electric KleenScreen PLUS® Models VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Filtering Instructions for KleenScreen PLUS® Fryers General The KleenScreen PLUS® filtration system filters the oil as it is pumped back into its’ respective tank(s). Only one tank can be drained and filtered at a time. Under no circumstances should both tanks be drained at the same time. Assembly • After unpacking, wash the filter pan, crumb basket and filter screen assembly. Make sure you remove the insert located inside the filter screen.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Fully assembled filter screen assembly: Fig. 2 Secure Tube with Suction Tube Clip Filter Screen Lays Flat On Bottom of Filter Pan Fig. 3 Micro-Filtration Fabric Envelope Assembly: Same Suction Tube Fabric Envelope Insert (Different from Screen Assembly) Fabric Envelope Closing Clip Same Knurled Knob Fig. 4 VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREEN PLUS® FILTER ENVELOPE FOR ABSOLUTE FILTRATION & MAXIMUM FLOW RATE WE RECOMMEND YOU CHANGE YOUR FILTER ENVELOPES AT EVERY OIL CHANGE (10-14 DAYS DEPENDING ON OIL USAGE). Step 1 Discard all oil from the filter vessel, (see pages 23 or 24). When the filter pan is empty, use a spatula and scrape off all debris left on the filter envelope and in the filter pan.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS Operation Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound from the tank. Never run water or boil out solution through filter and motor / pump. Doing so will void your fryer warranty. FILTERING PROCEDURE Oil Temperature should be 300-350° F.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS VULCAN-HART F-32959 Rev.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS FILTERING TIP: Open the filtering drawer approximately 1” to allow any oil in the return line to run back into the filter pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter components. REMOVING EXCESS DEBRIS FROM THE SCREEN FILTER: 1. Pull the filter drawer out and remove the crumb basket and empty any debris into the trash. 2. Remove the filter screen assembly. Scrape debris from the filter screen.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS BOIL OUT PROCEDURE: Use the Boil Out By-Pass™ drain extension allowing the boil out solution to exit the fry tank without using the filtering system. Do not allow water to run through the motor / pump. Drain the boil out solution into a bucket or place a hose on the end of the drain extension allowing the other end to flow into a floor drain. In Fig. 6 the arrow is pointing to the drain extension.
ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS MAINTENANCE Hot oil and hot parts can cause burns. Use care when operating, cleaning, and servicing the fryer. Spilling hot fryer compound can cause severe burns. Do not move fryer without draining all frying compound from the tank. Service in the US and Canada Contact your local Vulcan-Hart Service office or address on the front of this manual. In Australia Contact Hobart Food Equipment PTY. LTD., 16 Hilly Street Morlake, N.S.W. 2137 Australia; P.
