Fryer User Manual

GRDF / GRCF SERIES GAS FRYERS
VULCAN-HART F-32933 Rev. G (May 2009)
-24-
FILTERING TIP:
Open the filtering drawer approximately 1” to allow any oil in the return line to run back into the filter
pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter
components.
REMOVING EXCESS DEBRIS FROM THE SCREEN FILTER:
1. Pull the filter drawer out and remove the crumb basket and empty any debris into the trash.
2. Remove the filter screen assembly. Scrape debris from the filter screen. Then remove the
insert by unlatching the latch. Clean all parts thoroughly as mentioned in the Assembly
section on page 19.
3. Scrape debris from the bottom of the filter pan and discard in the trash. Clean all parts
thoroughly as mentioned in the Assembly section on page 19. Clean all parts thoroughly as
mentioned in the Assembly section on page 19.
4. Reassemble all filter components after being dried thoroughly as in the Assembly section on
page 19.
FLUSH AND DISCARD:
1. Follow filtering instructions 1-3, however do not put oil treatment media into the fryer. Drain
the fryer oil into the filter pan.
2. Attach the quick disconnect hose to the discard male quick disconnect fitting, (hose not
supplied with fryer – Accessory Option).
3. Place other end of the discard hose into a container that is large enough to retain the
discarded shortening.
4. With the power switch still ON; pull the Yellow Discard Handle Lever Rod towards you. Use
the control that is directly above the discard connection when flushing or discarding
shortening. Press and hold the filter button for at least 3 seconds and the Motor/Pump will
begin to operate. NOTE: Oil will come out immediately out of the nozzle end of the hose.
5. Once the oil has been discarded completely and the filter pan is empty, press the filter button
to turn off the Motor/ Pump. Then push the Discard Lever back in.
6. Disconnect the discard hose. The hose connection will be hot due to the temperature of the
oil that was discarded. Be careful to let the hose drain before putting away. Close the drain
valve and fill the fry tank with new oil.