User's Manual

– 39 –
SYMPTOM SUGGESTED CORRECTIVE ACTION
Steam button, Combi button and
Steam Factor lights are all flashing.
Oven works in Hot Air mode but not in Steam or Combi modes. The
treated water supply valve is off. Open the water supply valve. Turn
oven off and then back on. Allow the steam generator to preheat.
The Air Intake Trouble
Indicator Light is lit.
The air supply to the convection burner is blocked. Press the left Reset
button. If the problem persists, clean the air filter, as follows:
To clean the Air Intake Filter, unplug the electrical power cord. Remove
two acorn nuts on the Air Filter Panel — this is located on the left side of
the oven on a 10 level full depth oven and on the right side of the oven
on a 10 or 20 level half depth oven. Remove the metallic grease filter
and wash it in warm soapy water in a sink. Rinse the filter and allow it to
air dry. Replace all parts. For oven clearance requirements, refer to
Location (page 5). If the problem persists, contact service.
The Heat Trouble
Indicator Light is lit.
The Convection Burner has failed to ignite. Make sure the gas valve is
on. Press the left Reset button. If the problem persists, contact service.
The Steam Trouble
Indicator Light is lit.
The Steam Generator has failed to ignite. Make sure the gas valve is on.
Press the right Reset button. If the problem persists, contact service.
The Fan Trouble
Indicator Light is lit.
The Oven Fan has failed. Press the right Reset button. If the problem
persists, contact service.
[ OUR ] displays in the temperature
display.
There is an obstruction in the cavity vent on top of the oven. Unplug the
electrical power cord and remove any obstruction from the cavity vent.
[ 888C ], [ 888F ], [ 999C ] or [ 999F
] displays in the temperature
display.
One of the temperature sensors is faulty. Contact service.
[ 00 ] displays in the time display
while the temperature probe is in
use.
The temperature probe is faulty. Contact service.
Power failure occurs while food is in
the oven.
Open the door manually, as follows: Switch the oven off. Pull the door
handle firmly towards you while firmly pressing against the front of the
oven with your other hand. This procedure is not to be used during
normal operation. If the electric door opener fails to operate, contact
service.
The oven cannot be started and the
temperature display blinks.
Make sure the door is properly closed with the handle rotated back into
the recess at the corner of the door (refer to Fig. 4 on page 10).
Oven controls display is blank and
inoperative.
Make sure the electrical power cord is plugged in and that the receptacle
has power. If this does not correct the problem, contact service.
Temperature flashes and buzzer
sounds while the temperature probe
is in use.
Food ready to be cooked in the oven cannot be below 35
O
F (2
O
C).
Temperature display flashes the
current oven temperature.
Make sure the door is closed and the handle is in the closed position
(refer to Fig. 4, page 10).
Controls operate but oven will not
work in Hot Air or Steam modes.
Make sure the door is closed and the handle is in the closed position
(refer to Fig. 4, page 10).
Steaming will not occur if the cavity temperature is above the set point
temperature.
Controls operate but oven will not
work in Steam mode.
Oven temperature is above the boiling temperature of water (212
O
F or
less at higher elevations). Water supply valve is off. Open the water
valve.
TROUBLESHOOTING