User guide
— 11 —
Snorkel Oven
Remove lower front kick plate. Remove two screws holding electric gas valve and move valve off to
the side. Pull oven burner out of compartment through opening. Adjust four corner bolts to level range.
Replace burner valve and kick plate.
Floor Installation on Legs
The 6" (15 cm) adjustable legs must be tightened securely. Level each range by turning the foot
portion of the adjustable legs.
Lining up Range Battery
In batteries of ranges, it is recommended that the center range be installed and leveled first. Level
each range, one at a time, to line up high shelf and roll front with adjacent range. Bolt the high
shelves
and roll fronts together.
CONNECTION OF MANIFOLDS IN BATTERY
Two or more ranges can be coupled together at the manifold by removing the front control panel to
make necessary connections. Be sure to cap open ends. To connect:
1. Adjust manifold by loosening U-bolts. In a large battery of eight or more ranges, gas should be
fed from both ends of the battery. "T" gas connections can be installed whenever necessary for
increased gas supply. For further details, consult your gas company. The top roll front may also
be removed for your convenience.
2. Bolt risers together at top rear.
3. If risers have high shelves, bolt the high shelf brackets together. Replace the high shelves.
4. Use clamp to pull ranges together at the rear. (There is a slotted hole in the top frame side at
the rear that can be used to bolt ranges together if necessary. Run a
5
/16" diameter drill through
the slotted hole, drilling from inside out on each range.) Use
1
/4"-2 x 2" bolt that is provided.
5. Replace all top sections. Make manifold union connections at the front. Do not allow manifold
pipe to turn.
6. Bolt the roll front ends together at the front. (Make sure roll fronts match.) Use
1
/4"-20 x 1" bolts
provided.
7. Tighten the front roll front bolts after the roll front ends have been properly bolted together.
8. Before replacing manifold panels, check all gas connections for leaks. (See GAS CONNECTIONS
in this manual.)
If appliance has rear gas connection, carefully check for open gas lines.
The gas pressure regulator must have proper outlet pressure capacity for this battery application.