Owner manual

V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09)
13
LEAD WIRES LEAD CONNECTORS
ELEMENT WIRES Fig. 20
6. Reconnect the replacement
element to the lead wires with
New wire connectors.
7. Gently tuck the residual wire back
through the wire housing hole
until the backing plate is lined up
with the mounting holes, and is
flush against the inner liner of the
cabinet.
8. Complete the installation by
reversing the above steps.
9. Reconnect the cabinet to its
power source and test.
POWER CORD
1. Remove the cover.
2. Refer to the wiring diagram to
identify the electrical leads that
connect to the power cord.
3. Disconnect the wire leads to the
power cord.
4. Unscrew the retaining nut that
holds the power cord strain relief
to the cover.
5. Remove the power cord.
6. Install the replacement cord by
inserting the cord and threaded
portion of the strain relief through
the opening in the cover.
7. Complete the installation by
reversing the above steps.
8. Reconnect the cabinet to its
power source and test.
DOOR INSTALLATION
1. Using a flat head screwdriver, pry
the hinge cover away from the
hinge until it snaps out.
Caution: Use care not to scratch
the hinge cover. Look for the
small indentation on the inner
portion of the hinge cover, as the
location to pry the cover.
2. Remove the three (3) phillips
head screws that attach the hinge
to the door. Remove six (6)
phillips head screws to replace
hinge. (Fig. 21)
Fig. 21