Service manual

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS
Page 12 of 40
HOT SURFACE IGNITOR (GAS)
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
WARNING:
SHUT OFF THE GAS SUPPLY
BEFORE SERVICING THE UNIT.
1. Remove the right side panel as outlined under
"COVERS AND PANELS".
2. Cut the wire ties around “wire bundle” and trace
the wire for the Hot Surface Ignitor (HSI) to an
in-line splice (butt connector) and cut the wire
off close to the connector.
3. Remove the screw that holds the flame sense
probe and ground terminal wire onto the
mounting bracket and lift out.
4. Reverse the procedure to install then check HSI
for proper operation as outlined under “HOT
SURFACE IGNITOR”.
NOTE:
The opposite end of the in-line splice will
have to be cut, close to the connector and the wire
insulation stripped back approximately 0.250 inch to
install a new connector.
GAS BURNER
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove the right side panel as outlined under
"COVERS AND PANELS".
2. Remove the screws securing the burner
mounting bracket to the burner box frame.
3. Slide the burner forward enough to clear the gas
nozzles and lift it out.
4. Remove the screws securing the burners to the
mounting bracket and lift the burners off.
5. Reverse procedure to install then check for
proper operation.
NOTE:
When checking for proper operation, make
sure burner flame is not impinging on the opening of
the burner box.