Service manual

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS
Page 19 of 40
Handle
1. Open the door.
2. Remove screws from the top and bottom of the
door.
3. Pull the “inner” door panel out from the door
housing with the gasket plate and gasket still
attached.
4. Remove the nuts and spacers from the handle
screws and remove the handle from the door.
NOTE:
When installing the spacers, the smaller
diameter fits into the slot in the door and the latch
lever must rest on top of the handle latch screw.
5. Reverse procedure to install.
Latch Assembly
1. Open the door.
2. Remove screws from the top and bottom of the
door.
3. Pull the “inner” door panel out from the door
housing with the gasket plate and gasket still
attached.
4. Remove the screws from the side edge of the
door that secure the latch mechanism and
remove the latch from the door.
NOTE:
When installing, the latch lever must rest on
top of the handle latch screw.
5. Reverse procedure to install.