Service manual

VSX SERIES STEAMER - SERVICE PROCEDURES AND ADJUSTMENTS
Page 22 of 40
DOOR SEALING ADJUSTMENT
1. Check the door gasket quality. If damaged or
worn, replace as outlined under “DOOR”.
2. Loosen screws until the screw heads no longer
touch the gasket plate.
3. Tighten screws until screw head touches gasket
plate and at that point begin counting turns.
4. Tighten all screws approximately two turns.
5. Close the door and check unit for proper
operation.
6. If necessary, tighten all screws an additional ½
turn and repeat step 5.
7. Repeat step 6 until the door closes properly and
no steam “leaks” are seen around the gasket
seal.
DOOR LATCH ADJUSTMENT
Should the cooker door jam and can not be opened,
DO NOT FORCE OR PRY
the door as damage will
occur.
First, try lifting up on the bottom of the door at the
handle end, to disengage the latch.
If that does not work, remove the right side panel.
The striker that catches on the “door latch” is
located behind the front face of the cooking cavity.
Remove the nut from the striker and this will release
it from the panel.
Once the nut and washer have been removed, door
will open freely.
Remove any burrs on the striker that may cause the
latch to stick.
Reinstall the striker and adjust, so door will not jam.
To adjust
:
1. Reinstall the striker with the slot pointing
upwards and “hand tighten” nut only.
2. Close the door to center the striker in the oval
mounting hole.
3. Open the door and check the strikers’ slot for
horizontal alignment. The slot on the striker
must be kept horizontal in order for the door
latch to catch it properly and latch.
4. Once the proper slot alignment has been set,
hold the striker close to its base using a rag and
vise grips, then tighten the striker nut. Be
careful not to damage the striker “slot” when
tightening or door may not latch properly.
NOTE:
Do not over tighten as the striker will begin
to turn and change alignment.