Hot Beverage Maker User Manual

ELECTRIC COUNTER TOP TILTING KETTLES - REMOVAL AND REPLACEMENT OF PARTS
SHAFT SEAL
All Models
1. To access shaft seal between kettle and control
box housing, remove KETTLE ASSEMBLY.
2. Remove shaft seal from control box housing.
3. Clean mounting surface on control box housing
then install replacement shaft seal.
4. Install KETTLE ASSEMBLY.
K20ETT only
1. Support kettle using 2x4 blocks of wood.
2. Remove kettle support cover.
3. Remove kettle support and bearing housing
assembly from support shaft.
4. Remove shaft seal from kettle support.
5. Clean mounting surface on kettle support then
install replacement shaft seal.
F35496 (August 2009) Page 12 of 28