User Guide

ELECTRIC COUNTER TOP TILTING KETTLES - REMOVAL AND REPLACEMENT OF PARTS
6. Reverse procedure to complete the installation
and check for proper operation.
PIVOT STOP PIN
1. Remove CONTROL BOX COVER.
2. Remove retaining ring from pivot stop pin.
3. Reverse procedure to install.
NOTE: When installing, apply Lubriplate 630-AA to
mating surfaces on pivot stop pin. Ensure pivot stop
pin fully engages with the slot in pivot stop collar and
does not catch or bind when tilt lock is operated. The
picture below is shown with outer bearing removed
for clarity.
K20ETT WITH SHAFT SEAL INSTALLED
F35496 (August 2009)Page 13 of 28