Gas Heater User Manual

– 6 –
Fig. 3
VENT GUARD
TWO PIECE
STACKING
COMMON FLUE
PL-52884
If disconnection of the restraint is necessary, turn off the gas supply before disconnection. Reconnect
the restraint prior to turning the gas supply back on.
Separate instructions for installing casters to the oven are included with the casters.
Assembling the Legs to the Oven
The legs must be installed on the bottom of the oven. Position
oven on its back, taking care not to scratch or damage it. The gas
pipe connection protrudes beyond the back; provide for this when
the oven is tipped back by resting it on suitable spacers (2 x 4's
etc.).
Attach each of the four leg assemblies to the bottom of the oven
with the 24 bolts and lockwashers (6 per leg). Carefully raise the
oven to its normal position.
Assembling the Stand to the Oven
Attach each of the four leg assemblies to the bottom of the oven
with the 24 bolts and lockwashers (6 per leg). Carefully raise the
oven to its normal position.
Attach the undershelf to the legs with 8 bolts and lockwashers (2
per leg).
Install the rack guides into the shelf at desired locations (for pan
or flat rack), then attach the rack supports to the top end of the rack
guides. Attach rack supports to the leg assembly by removing one
middle bolt and reattaching back through the end holes in the rack
support (Fig. 2).
ASSEMBLING STACKED OVENS
Unpack the ovens and stack kit. Position
the lower oven on its back for access to the
oven bottom, taking care not to scratch or
damage it. The gas pipe protrudes beyond
the back; provide for this when the oven is
tipped back by resting it on suitable
spacers, 2 x 4's, etc. Attach the four leg
assemblies with 24 bolts and lockwashers
(6 per leg).
Place the lower oven (with legs or casters)
on the floor and remove two
7
⁄16" (1.1 cm)
diameter knockouts on each side of the top
cover. Remove vent guard and discard it.
Move the oven to the installed position and
place upper oven on top of lower oven
using the locating studs.
Fig. 2
BACK
FRONT
PL-52821