Fryer User Manual

VK SERIES GAS FRYERS
VULCAN-HART F-32971 Rev. F (December 2011)
-27-
BOIL OUT PROCEDURE:
Use the Boil Out By-Pass™ drain extension allowing the boil
out solution to exit the fry tank without using the filtering
system. Do NOT allow water to run through the motor / pump.
Drain the boil out solution into a bucket or place a high
temperature rated water hose on the end of the drain extension
allowing the other end to flow into a floor drain. In Fig. 6 the
arrow is pointing to the drain extension. It is threaded into the
top coupling of the oil drain tube. Drain extension needs to be
only hand tightened.
Fig. 6
Standard Hose End Drain Tube End
THERMAL OVERLOAD PROTECTION BUTTON:
The motor/pump supplied with the
filtering system has a thermal
overload protection circuit that
senses when excess heat occurs.
This can occur due to filtering for
long periods of time or under heavy
load prior to discarding debris
buildup. If the thermal overload
protection is tripped, wait 5 minutes
and then reset the motor by pushing
in the red button. The arrow in
Figure 7 shows the location of the
reset button; located on the front off
the motor / pump facing towards you.
Hot oil and hot
parts can cause burns.
Fig. 7