Charcoal Grill User Manual

-
8 -
OPERATION
The charbroiler and its parts are hot. Use care when operating,
cleaning or servicing the charbroiler.
BURNER LIGHTING
The burners should be left on the maximum (MAX) setting for most efficiency when
cooking. The burners may be turned to the minimum (MIN) setting during slow periods to
save energy. See Fig. 6.
The VTEC charbroiler does not have a pilot
and each burner lights directly from a spark
igniter or from an outside ignition source (such
as a lit taper, long handle lighter, etc).
LIGHTING BURNER WITH SPARK IGNITER
1. Turn the main gas shut-off valve and the
individual burner control knobs to the OFF
position (clockwise until stops). Wait 5
minutes.
2. Push and turn the burner control knob to the
MAX setting (counterclockwise to vertical/90°
position) on the burner you intend to light.
(Fig. 5)
3. Immediately, while viewing through the
burner sight hole, turn the igniter knob
clockwise until you hear a click (approx. ¼
turn) and see the spark. The burner should
ignite immediately and flames should be
visible through the burner sight hole.
4. If the burner fails to light immediately,
repeat step 3, two more times. If the burner
has still not ignited at this point, turn the
main gas shut-off valve and all burner
valves to the OFF position (clockwise until
stops) and proceed with manual burner
lighting instructions on following page.
5. Repeat steps 2-4 until all burners are lit.
Turn on one burner control knob at a time
and ensure burner is lit before proceeding
to light the next burner.
Fig. 6
Fig. 5
Burner Sight Hole
Burner Control Knob Igniter Knob
OFF MAXIMUM MINIMUM